Stainless Handles for Raising & Lowering Fryer Screen, Replaces Belshaw Adamatic 616-0007C - Pack of 2 - Used Like New

For effective use of this handle, squeeze it before inserting in the holes of the fryer screen, then stop squeezing for the notches of the handle to catch onto and hold the mesh wires of the screen. Squeeze again and pull out to remove the handle from the screen.

• Handle with notch on each side for gripping fryer screen by the mesh wires
• Fits any handleless deep-fat-fryer screen
• Eliminates need for non-detachable screen handles
• Makes it easy to lower the screen into and lift it out of the fryer

Handle consists of a stainless steel spring that is wound around and welded at its two ends to a single stainless steel wire, which twists to form two wires that crisscross, each wire then bending and continuing straight until the end.
7/16 inch from each tip is a notch that grabs the mesh wires of the fryer screen.

Spring is 4 inch wide and coiled into circles measuring 1-3/8 inch in diameter.

Wire is 1/8 inch thick.
Wire of spring is between 1/16 inch and 1/8 inch thick.
Overall size of each handle (counting the spring) is 5 inch x 15-3/4 inch x 1-3/8 inch high.

Shop More Fryers & Cooking Equipment >