Description
For effective use of this handle, squeeze it before inserting in the holes of the fryer screen, then stop squeezing for the notches of the handle to catch onto and hold the mesh wires of the screen. Squeeze again and pull out to remove the handle from the screen.
- Handle with notch on each side for gripping fryer screen by the mesh wires
- Fits any handleless deep-fat-fryer screen
- Eliminates need for non-detachable screen handles
- Makes it easy to lower the screen into and lift it out of the fryer
7/16 inch from each tip is a notch that grabs the mesh wires of the fryer screen.
Spring is 4 inch wide and coiled into circles measuring 1-3/8 inch in diameter.
Wire is 1/8 inch thick.
Wire of spring is between 1/16 inch and 1/8 inch thick.
Overall size of each handle (counting the spring) is 5 inch x 15-3/4 inch x 1-3/8 inch high.
Specifications
| Dimensions and Weight | |
|---|---|
| Diameter | 1.37" |
| Features | |
| Material | Stainless steel |
Reviews
(2 reviews)
Not good quality
I had to modify the slots to fit my screens and the tip ended up falling off after only 5 uses.
By Sylvia P, Indiana on October 9, 2020
Well built and some small adjustment needed
The steel built feels like it should last much longer then previous handles.
We had to grind out the screen slots as they were just a fraction to small.
By Dan Morris, Oregon on September 11, 2017